Sign up to never miss a deal!

  • Save and watch items
  • Follow categories
  • Message or follow this seller

Item may be too far from your current location


Pioneer Stereo Receiver SX-1500TD

A Powerful Receiver of Tremendous power and Fidelity, Beautifully Packaged in the Most Up-to Date Design.
The SX-1500TD features highly advanced circuitry. An FET frong and ensures extremely sensitive FM reception. There are four IC's in the IF section for excellent selectivity, and a monolithic IC in the multiplex section for improved separation. Silicon transistors ensure low-noise music power of a tremendous 180 watts. In addition, a fine dynamic microphone comes with the SX-1500TD for microphone mixing. You can connect up to three different stereo loudspeaker systems. Uniquely attractive, with its silver and black contrast and polished rosewood end-pieces.

Center Channel Output
The SX-1500TD has a center channel output on the rear panel, providing the composite signal (L+R) for a 3-D (three-dimensional) system, when you connect another amplifier to the center channel output. In addition, stereo music can be recorded into a monophonic tape recorder with this output which is controlled by the preamplifier section of the SX-1500TD.

Phono Inputs
The SX-1500TD has two sets of phono inputs, enabling you to compare cartridges. Phono 1 is for magnetic and ceramic cartridges, and Phono 2 is for magnetic cartridges.

AC Outlets
There are three AC outlets for turntables and tape decks used with the receiver, a switched AC outlet for 230 VA and two unswitched AC outlets for 230 VA.

FM Section
Circuity: Front end using FET and 4-gang variable capacitor, IF amplifier using 4 IC's
Frequency Range: 87,5 to 108 MHz
IHF Usable Sensitivity: 1,7 µV
Capture Ratio: 0,7 dB 9at 98 MHz)
Image Rejection: 72 dB (at 98 MHz)
Selectivity: 40 dB (IHF rating)
Signal-to-Noise Ratio: 60 dB (IHF rating)
Antenna Input: 300 Ω (balanced)
Multiplex Section
Circuitry: Time-switching type demodulator using IC, FM mono/stereo automatic selection
Channel Separation: 38 dB (at 1 kHz)
AM Section
Circuitry: Superheterodyne
Frequency Range: 525 to 1605 kHz
IHF Usable Sensitivity: 18 µV
Image Rejection: 77 dB (at 1,000 kHz)
Antenna Input: Built-in ferrite loopstick antenna
Audio Section
Circuitry: Single-ended push-pull
Music Power Output:
180 watts total at 4 Ω (IHF rating)
145 watts total at 8 Ω (IHF rating)
Continuous Power Output (each channel driven):
70 watts / 70 watts at 4 Ω;
58 watts / 58 watts at 8 Ω
Harmonic Distortion: less than 0,5% 9at 1 kHz rated output)
Damping Factor: 50 at 8 Ω (at 1 kHz)
Frequency Response: 10 to 10,000 Hz ±2 dB
Power Bandwidth: 15 to 40,000 Hz (Aux/IHF)
Hum and Noise (at rated output):
Mag : better than 80 dB
Aux : better than 100 dB
Inputs Sensitivit/Impedance (for rated output):
Magnetic Phono : 3,3 mV/50 k Ω
Ceramic Phono : 24 mV/100 k Ω
Microphone : 3,2 mV/30 k Ω
Tape Monitor : 200 mV/100 k Ω
Aux : 200 mV/100 k Ω
Main In : 480 mV/80 k Ω
Outputs Terminals and Jacks:
Speaker Impedance 4 to 8 Ω
Stereo Headphone jack
Simultaneous tape recording jacks, equipped with Tape Monitor switch
Tape Recording/Playback jack (DIN standard)
Pre-amplifier output jakcs
Center channel output jack
Equalization Curve: Phono RIAA
Tone Controls (each channel):
Bass : boost 11 dB, out 16 dB at 50 Hz
Treble : boost 10 dB, out 9 dB at 10 kHz
Low : out 8 dB at 50 Hz
High : out 6 dB at 10 kHz
Loudness Contour: Switchable to On-Off, boost 12 dB at 50 Hz, boost 9 dB at 10 kHz, with Volume control set at -40 dB
Power Supply: 110, 117, 130, 220, 240 V (switchable), 50/60 Hz, 250 VA, 230 watts max
Dimensions (W x H x D): 459 x 145 x 369 mm (18-1/16" x 5-11/15" x 14-1/2")

Weight: 11,4 kg (25 lbs 2 oz) net

Available in the following communities
Youngstown, OH Buy and Sell

seller info

Profile picture?fit=crop&height=50&width=50


11 Items
© 2024 VarageSale, inc. All Rights Reserved.